How To Start A Gas Fireplace With A Switch. Turn on all the electric power to your fireplace. To ignite the pilot light, press your finger into the center of the control knob and hold it in place.
Your voltage line should be. Turn the key counterclockwise to start. To ignite the pilot light, press your finger into the center of the control knob and hold it in place.
Press The Control Knob Down And Hit The Ignition Switch.
To turn on a gas fireplace with a wall switch, simply locate the switch in the control panel and push the “on” button.today’s modern gas fireplaces are typically controlled with a. To ignite the pilot light, press your finger into the center of the control knob and hold it in place. Switch the pilot switch to.
To Turn On Your Gas Fireplace With A Control Unit, Complete The Following Steps:
Slide the provided spade connectors. Light a match near the fire’s piping, while holding down the pilot lighter. Connect the wires to them.
How Do You Start A Gas Fireplace With A Keyhole?
Then, pull the switch back just far enough to allow for access to the dual wires located on the side of the switch. Check for a loose wire connection on the terminals. Turn the key counterclockwise to start.
To Ignite The Pilot Light, Press Your Finger Into The Center Of The Control Knob And Hold It In Place.
Then, hit the fireplace's ignition switch,. All direct vent gas fireplaces are sealed, keeping emissions out, and are. Do gas fireplaces need electricity to start?
Now, Turn The On/Off Switch To The On Position To Light The.
Press the control knob down and hit the ignition switch. Insert the end of the key into the keyhole until it locks in place. Turn off the control knob for.